![]() |
. | ![]() |
||||
. | ![]() LED Based Aviation Obstruction LightSpaceage is the pioneer in uniform intensity LED based Aviation Lights as per ICAO standards. We offer 24V DC/48V DC/230V AC, 10cd/33cd lights (Type A / Type B) lights with or without light/photo sensors/switch. We offer internal/external SMPS/Sensor. More then 75,000 of our Aviation lights supplied till date. LED Aviation Obstruction Light/LampOur distinguishing features are:
Range of ModelsWe have many versions of Aviation Lights to suit every need. We offer following broad categories
General features
Uniform lighting (ALL models)
This is one of the two requirements of ICAO for aviation lights (the other being light intensity). Since the time, LED lights were introduced, it was a challenge as to how to produce uniform intensity from directional LEDs, since the PCB's on which these are mounted are flat. Our engineers have come out with a solution, finally!! Due to the hard nature of PCB on which LEDs are mounted, most the lights in the market have 6 or 8 faces. Since the light from LED's is directional in nature, the light from such aviation light is not uniform but is a set of 6 or 8 streaks.
However, in case of Spaceage lights, the light pattern is If Light intensity is plotted from the centre of the light (PLAN view), Common features
INPUT VOLTAGE PROTECTION
LEDs are known to be very sensitive to input voltage. A change of even 0.1 V to the LED can effect the performance. If the voltage is low even marginally, the intensity of light reduces exponentially. However, if the voltage is higher even marginally the LED's life is reduced dramatically. If continuous over voltage is applied the LED turns yellow and then brown with drastic reduction in emitted light. Most of times the LED based Aviation light performs well for few days but then give reduced intensity due to this problem. Most of the manufacturers specify a fixed voltage only for their products. However in real life the voltage changes due to charging surges. In Telecom sector, where the voltage is 48V, it is usual to find voltages up to 54V when the batteries are getting charged. To overcome this, we supply our light with a voltage regulator that can take voltages from 42V DC to 56V DC without affecting the LED's in any way. We also have models that work on 24VDC as well as 48V DC without any modification or jumper setting. Note: We reserve the right to revise features and cost at any time, without any prior notice |
. | ||||
![]() |
. | ![]() |